Water Based Varnish brand

Water Based Varnish brand Water based varnish matt has good surface spreading and brushing performance. It is suitable for polishing equipment of coater, flexographic machine and offset printing machine. The surface of its polishing products is plump and smooth. And it has good water resistance (after complete drying). When using water-based matte oil, it can be diluted with water, and its ratio is glazing oil: water = 10:3 Water based varnish matt has excellent dullness, good wear resistance, good transparency, fast drying and good printability. It has good wettability and leveling for wet press wet and wet press dry printing, and the printing machine is easy to clean. water based varnish matt meets the national and EU environmental protection standards and passes the EU ROHS inspection. It is suitable for high-end packaging such as food packaging, footwear, electronics and appliances, medicine, tobacco and alcohol. This varnish is used for online polishing and offline polishing. 1. Basic Introduction Waterborne Matt oil is a matte water-based glazing emulsion for paper. It is a matte emulsion specially designed for general printing paper. It can give the paper excellent visual effect, good transparency, little impact on printing color, good abrasion resistance, good resistance to overlap and good water resistance. Waterborne matte oil is a non toxic, solvent free emulsion, which does not pollute the environment. It meets the environmental hygiene standards. 2. Precautions (1) This product can be diluted with clean water to adjust the coating viscosity before use. It is recommended to add 10% ~ 15%. (2) After use, it can be directly cleaned with clean water. (3) This product is placed in a cool place and cannot be directly exposed to light or high temperature. The general storage life is 12 months. (4) This product does not contain organic solvents, has no spontaneous combustion and explosion, and has very low corrosivity. It can be used safely. During operation, avoid Avoid direct contact with skin. In case of accidental contact, clean it with soapy water immediately. (5) Instantaneous flammability: none. Fire extinguishing material: foam or carbon dioxide fire extinguisher. Characteristics of water-based matte oil: wear resistance, good scratch resistance, and the matte degree can be adjusted according to customer needs. It is suitable for all kinds of on-line polishing and off-line polishing. Use Guidance 1. Dilution: stock solution is recommended 2. Diluent: water or 1:1 (ethanol: water) solution (the choice of diluent depends on the drying system of the polishing equipment. When diluting, be sure to mix ethanol and water first, then add them into the polishing oil and stir evenly.) 3. Diluent dosage: the specific dosage should be tested first, so as not to affect the product quality and make the glazing equipment operate normally. Avoid excessive dilution, which will seriously affect the performance of the product. 4. Application range: the temperature of hot plate is 160 掳 c-200c. Suitable for flexographic printing, gravure printing and polishing. Matters needing attention 1. Solvent, alkali and alcohol resistant inks are recommended. 2. The equipment can be cleaned with water, and the dry varnish can be cleaned with ethyl acetate. Pay attention to ventilation and explosion-proof during cleaning. 3. When diluting and adjusting viscosity, it is recommended to do experiments first. If the surface drying is slow, the oven temperature can be appropriately increased. 4. This product should be placed in cool, dry and ventilated conditions, anti freezing and high temperature above 35 鈩?(sun and heater). 5. When placed for a long time, it should be stirred evenly before use.Water Based Varnish brand website:http://www.kageminks.com/water-based-varnish/